VFR example

In this document, we use the following convention:

The ATC is the one that may start using the short call sign. Only
thereafter the pilot shall use it as well.

VFR departure

VFR Initial Clearance

Outbound flight with no restrictions:

Outbound flight with a VFR departure published:

Flight for aerodrome circuit pattern :

ATC can give the circuit parameters in the clearance :

VFR Take off

When the VFR pilot approaches the holding point of the active runway:

Take-off after a line up :

Direct take-off with a report over VFR point:

Direct take-off with a report in circuit pattern:

Direct take-off with a report over airfield for an exercise:

VFR Cruise

VFR Initial climb

When leaving the sector :

Or on VATSIM:

Special VFR will be cleared to leave the control zone in accordance with established procedures:

VFR Altitude

Level change:

Reported flight level requested by ATC:

Level change using conditional clearance:

Once having been given an instruction to climb or descend, a further overriding instruction may be given to a pilot:

Usually at first contact in cruise, ATC can request pilot to maintain current altitude:

Occasionally, for traffic reasons, a higher than normal rate of descent (or climb) may be required in order to free the higher flight level left:

As a pilot if you are unable to follow the expedite clearance you shall report that to ATC:

Once having been given an instruction to climb or descend, a further overriding instruction may be given to a pilot:

VFR Transit

The aircraft has now been transferred to Dinard Tower to transit via the class D CTR:

When pilot is over airfield:

VFR Arrival

VFR Arrival in terminal area (APP)
VFR Arrival in aerodrome circuit (TWR)

Join VFR point from another at the request of ATC:

Join aerodrome circuit from VFR entry point:

VFR straight-in approach:

VFR in aerodrome circuit

Join final from end of downwind:

Traffic information when performing pattern:

Traffic information with integration number and final report:

Traffic information with incoming traffic on final:

In case of effluence or runway occupation, ATC can request pilot to extend his downwind:

ATC can also issue a holding clearance (orbit in VFR):

VFR Landing

Full stop landing:

Touch and go:

Low pass:

Stop and go:

VFR Go around procedure

ATC requests a go around:

Pilot performs a go around:

After landing

Hand-Off with Ground Controller:

After vacating, the pilot in command shall ask a taxi clearance to continue:

Usually, the VFR pilot monitors the ATC frequency during taxi and quit.
If the pilot wants to give an acknowledgement to ATC, just do it like this:


Revision #5
Created 6 February 2025 03:56:49 by Ali
Updated 17 March 2025 02:15:22 by Ali